Datasheet

SLCFxxxM2TU(I)(-x) CompactFlash Card
Datasheet
61000-07000-106, May 2011 14
Signal Name
Type
Pin
Number
Description
-INPACK
(PC Card Memory Mode
except UDMA protocol
active)
-DMARQ
(PC Card Memory Mode:
UDMA protocol active)
O
43
This signal is not used in this mode.
This signal is a DMA Request that is used for DMA data
transfers between host and device. It shall be asserted by the
device when it is ready to transfer data to or from the host.
For Multiword DMA transfers, the direction of data transfer is
controlled by -IORD and -IOWR. This signal is used in a
handshake manner with (-)DMACK, i.e., the device shall wait
until the host asserts (-)DMACK before negating (-)DMARQ,
and re-asserting (-)DMARQ if there is more data to transfer.
In PCMCIA I/O Mode, the -DMARQ shall be ignored by the
host while the host is performing an I/O Read cycle to the
device. The host shall not initiate an I/O Read cycle while -
DMARQ is asserted by the device.
In TrueIDE Mode, DMARQ shall not be driven when the
device is not selected in the Drive-Head register.
While a DMA operation is in progress, -CS0 (-CE1)and -CS1
(-CE2) shall be held negated and the width of the transfers
shall be 16 bits.
If there is no hardware support for TrueIDE DMA mode in the
host, this output signal is not used and should not be
connected at the host. In this case, the BIOS must report that
DMA mode is not supported by the host so that device
drivers will not attempt DMA mode operation.
A host that does not support DMA mode and implements
both PC Card and TrueIDE modes of operation need not
alter the PC Card mode connections while in TrueIDE mode
as long as this does not prevent proper operation in any
mode.
-INPACK
(PC Card I/O Mode except
UDMA protocol active)
Input Acknowledge
-DMARQ
(PC Card I/O Mode: UDMA
protocol active)
The Input Acknowledge signal is asserted by the CF Card
when it is selected and responding to an I/O read cycle at the
address that is on the bus. The host uses this signal to
control the enable of any input data buffers between the CF
Card and the host’s CPU.
Same as (-)DMARQ above.
DMARQ
(TrueIDE Mode)
Same as (-)DMARQ above.
BVD1
(PC Card Memory Mode)
I/O
46
This signal is asserted high as since a battery is not used
with this product.
-STSCHG
(PC Card I/O Mode)
Status Changed
Asserted low to alert host to changes in READY, Write Protect
states. Use is controlled by Configuration and Status Register.
-PDIAG
(TrueIDE Mode)
In TrueIDE Mode, this input/output signal is the Pass
Diagnostic signal in the Master/Slave handshake protocol.