Instruction manual

12
13
4
5
DD-TEC16E DD-TEC16E
COMPONENTS
CONTROL PANEL
WATER TANK DRAINAGE
(OPTION A)
CONTINUOUS WATER DRAINAGE (OPTION B) FILTER CLEANING
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Cleaning the filter
4
5
DD-TEC16E DD-TEC16E
COMPONENTS
CONTROL PANEL
WATER TANK DRAINAGE
(OPTION A)
CONTINUOUS WATER DRAINAGE (OPTION B) FILTER CLEANING
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Empty water tank
4
5
DD-TEC16E DD-TEC16E
COMPONENTS
CONTROL PANEL
WATER TANK DRAINAGE
(OPTION A)
CONTINUOUS WATER DRAINAGE (OPTION B) FILTER CLEANING
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Continuous drainage
Tube
When the dehumidifier reaches the adjusted value, the compressor will stop wor- ∙
king and starts again when the humidity is again above the programmed value.
Keep doors and windows closed of the room which should be dehumidified. ∙
Take care that nothing can drop on the appliance. ∙
During use, the appliance will create warm air. ∙
To run the appliance continuously, turn the humidity regulator to “cont”. ∙
2. Air speed:
The air speed can be changed, by pressing the button “Speed”. In the display “Hi” is
shown for air speed or “Low” for low air speed. The adjusted air speed is shown in
the panel with “High” or “Low” lamp.
3. Timer:
a) When the time should be adjusted, then press the “Timer” button. The time can
be adjusted in steps of one hour from one to 24hours. The „Timer“ lamp at the
panel is on.
b) When the time runs out then the appliance will switch off automatically.
c) When the appliance will be switched off by pressing the “Power” button before
the timer runs out, then the rest time of the timer will be deleted.
4. Adjusting the humidity
Press the key to set the desired humidity (RH50%,60%,70%,80%AU,CO). The adjus-
ted humidity is shown at the display for a short time. Then the display switches and
the humiditiy of the room is shown. When the room humidity is 3% less than the set
humidity the compressor of the unit will turn off automatically. When the humidity
of the room is getting 3% higher than the set humidity, then the compressor will re-
start again automatically. If the „Run“ lamp is blinking, then the compressor does not
work. The humiditiy in the room is lower than the adjusted value. If the “Run” lamp is
permanently on, then the compressor is working.
Comfort mode (indicate AU in the display)
a) When ambient temperature is below 5·, the compressor will stop working.
b) When ambient temperature is at or above 5· and below 20·,the appliance will auto-
matically set the humidity level at 60%.
c) When ambient temperature is above 20· and below 27·, the appliance will automati-
cally set the humidity level at 55%.
d) When ambient temperature is above 27·,the appliance will automatically set the
humidity level at 50·
5. TANK FULL
If this indicator (WF) illuminates, it means tank is full of water, and unit will operate
with fan only(The compressor will stop running automatically, until the tank
is emptied).