Operation Manual

∙ If the surface is cracked, switch off and take to the service cen-

ter immediately.

∙ Do not block air intake or exhaust vent.

∙

Do not touch the top plate

shortly after removing the pot or the pan,

as the top plate will still be very hot.

∙ Do not place near objects which are affected by magnet, such

as: radios, televisions, automatic-banking cards and cassette ta-

pes.

∙ The supply cord must by replaced by qualified technicians.

How to Clean

∙ Disconnect plug and wait until it is cooled down. Clean after

each use.

∙ Never immerse the device in Water.

∙ If the pots/pans are used without being cleaned, discoloration

or cooked on stains may be caused.

∙ Do not use petrol, thinner, scrubbing brush or polishing power

to clean the induction cooker.

∙ Wipe using dish washing agent and damp cloth.

∙ Use vacuum cleaner to suck up dirt from the air intake and ex-

haust vent.

∙ Never run water over the unit. (water gets inside may cause

malfunction).

Operation:

The appliance is equipped with a touch control display- All functions will be

activated by touching the surface.

Plug the appliance into the socket. A sound can be heard, all LED and the display are

illuminated for one second. Now the appliance is in stand-by modus. A red LED shines

above ON/OFF

. Place a suitable pot in the middle of the cooking area (min. diame-

ter 12cm). By touching the ON/OFF

once 4 stripes and a LED above the ON/OFF

shines. Attention!!! After 30 seconds the appliance will switch back into the stand-

by modus, when no function or by touching was chosen. The fan runs for about 2

minutes.