Operation Manual

How to use the device

∙ Plug the device into an earthed socket.

∙ A signal tone sounds, the display is illuminated. The device is in stand-by mode.

∙ Place the induction suited cookware with a min. diameter of 12cm on the plate.

∙ Press the on/off

button. The display shows “ON”.

∙ Chose temperature or power with the select button .

∙ The temperature can be adjusted with the +/- button in steps of 60 – 80 – 120 – 150

– 180 – 200 – 220 – 240°C. The power in steps of 300 – 700 – 1000 – 1200 – 1400 –

1600 – 1800 – 2000 watts.

∙ The device starts.

∙ During operation, the temperature or power can be changed.

Timer

∙ If the temperature or power is set and no amendments are made, the device turns

off automatically after 2:59 hours.

∙ Press the timer button

. The display shows “0000”, after 5 seconds the device gets

back to normal operation.

∙ Max timer setting is 2 hours 59 minutes

∙ Set the hours with the

button.

∙ Set the minutes with the button.

∙ The time is accepted within 5 seconds and the time begins to count down.

∙ The display shows time and temperature in change.

∙ The time can be changed by pressing the timer button and the +/- buttons.

∙ After the time run out a signal tone sounds and the device switches automatically

into the stand-by mode.

Residual heat

∙ After turning off the device the display shows:

H the temperature of the plate is above 60°C

∙ The ventilation of the device runs for a couple of minutes after the device has been

turn off. Unplug after the ventilation shuts off.