GS08A OPERATION AND INSTALLATION GUIDE (CONTROL PANEL FOR STEAMSPA GENERATORS)
GS08A Cataloge Safety attention ----------------------------------------------------------------1 Safety operation instruction-------------------------------------------------1 Instruction of the control box------------------------------------------------1 Controller installation instruction-----------------------------------------2 Controller function instruction-------------------------------------------3-5 Brief Introduction-------------------------------------------------------------6 Controller and tem
GS08A Attention in controller 1.Use soft cloth with a little soap water to clean the controller. 2.Do not use crude cleaning tools. 3.If the decorating crust is damaged, telephone the service electrician to change it. Safety and operation information of the controller ! Warning: If the installation and operation instruction is not read or understood, do not install or use in case there should be any dangerous installation and improper operation.
GS08A Installation instruction of controller ! Important: Before installing the controller, make sure the steam generator is shut off otherwise the controller may lose control or be damaged. Step one Determine the installation location of the controller. The controller is designed to be installed in the steam room only, and while installing: 1.4-5 feet from the ground. 2.Keep away from the steam nozzle and do not expose under the direct spray of steam. 3.Install in the perpendicular wall. 4.
GS08A Step five Remove the closing paper at the bottom. To achieve good sticking effect, keep the sticking surface clean and dry. Step six Locate the display screen in the direction of 12 o'clock, and press tight the controller to stick it to the wall. ! To ensure horizontal installation of the controller, use a gradienter if necessary. Important: Step seven Drill a round hole of ะค0.
GS08A elements will stop heating and the water inlet valve will work automatically. If there is no water detected in 20 seconds or the water coming in does not reach the set point in 60 seconds, the digital tube will display to indicate an error of not enough water cycling. If there is enough water cycling, the steam function will return to normal.
GS08A 5. LIGHT FUNCTION When the machine is started , press button to turn on/off light function. When the light is turned on , the digital tube will temporarily display . When the light is turned off , the digital tube will temporarily display Screen will turn to display ambient TEMP if no operation is selected in 5 seconds. 6. REAL CLOCK TIME SETTING When system is on, keep pressing button till number of hour flash, press or to adjust clock time in hour.
GS08A Introduction of the control panel This model have main and sub control panel , both has same function , GS1090C is single control panel with main panel only , GS1090D is dual contorl panel with main&sub panel.
GS08A Installation of control panel and TEMP sensor One Way:Recess mount into wall 3.9 inches drill a round hole 5.6 inches to steam generator D control panel Screw 3.9 feet to 4.
GS08A Installation of control panel and TEMP sensor Two Way:Stick on the wall drill a round hole 1.378 inches to steam generator control panel 3.9feet to 4.
GS08A Installation of control panel and TEMP sensor Installation of TEMP sensor drill a round hole temperature sensor 0.4 inches Nut to lock the TEMP sensor holder temperature sensor holder Controller size and waterproof rating Control panel model GS1090C(single panel) GS1090D(dual panel) Panel size ( length*width*height) 5.9x3.5x1 inches 5.9x3.
GS08A Wiring Diagram D C Page 10