Integration Instructions

FCC AND ISED MODULE INTEGRATION INSTRUCTIONS
Page 3 of 4
FCC Regulatory Statements for this module
FCC Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this product does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modification not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure considerations:
This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.
Label considerations:
When the FCC ID is not visible when after installation inside another device, then the outside of the device into which
the module is installed must also display a label referring to the enclosed module. This exterior label can be use
wording: “Contains transmitter module FCC ID: 2AVL60001101” or “Contains FCC ID: 2AVL60001101”.