User Manual

8
|
ENGLISH
FILLING WITH WATER
1. Remove Water Tank from main unit.
2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a
counterclockwise direction (G).
3. Fill Water Tank with water through Valve Cap hole. At full capacity, the Water Tank holds
106 oz (3,135 ml) of water, and depending on the steam setting selected, will provide a
continuous steam time of 95 min. on High.
NOTE: In order to significantly reduce mineral build-up and prolong the life of your
Professional Fabric Steamer, use of distilled or de-mineralized water in the unit is highly
recommended. Refer to Page 12 for more information about mineral build-up.
CAUTION: Only water and vinegar should be used in unit – other chemicals or cleaning
agents may cause internal damage. If vinegar is used, please be aware that it will create
a smell. Do not attempt to substitute any other water tank for the one designed for use
with this unit.
4. Replace Valve Cap by rotating it in a clockwise direction.
5. Place Water Tank back onto main unit (H). The sound of water flowing from Water Tank into
Water Reservoir should be audible for a short period of time.
NOTE: Water Tank can be removed and refilled at any time during operation – there is no
need to turn unit off or allow any cooling period.
IMPORTANT: Do not attempt to operate unit with an empty Water Tank.
Using Your
Professional Fabric Steamer
G H