SF-452 HANDHELD FABRIC STEAMER OWNER’S GUIDE
IMPORTANT SAFETY INSTRUCTIONS This owner's guide and any additional inserts are considered part of the product. They contain important information about safety, use, and disposal. Before using the product, please familiarize yourself with all operating and safety instructions. Please keep all documents for future reference and pass these documents on, together with the product, to any future owner. See our website for the most current version of this owner’s guide.
potential build-up of mineral deposits. 15. To avoid burns from escaping steam when refilling Water Tank: • Always allow unit to cool for 5-10 minutes. • Press and hold Steam Trigger to release all remaining steam pressure. 16. To reduce risk of contact with hot water emitting from Main Nozzle, check appliance before each use by positioning it away from body and turning it on. Do not operate unit if Main Nozzle is blocked. 17. Burns can occur from touching hot metal parts, hot water, or steam.
Product Information The following features and accessories are included with your Handheld Fabric Steamer. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Page 9 of this manual for Consumer Service contact information.
• The Steam Nozzle (1) emits a flow of hot, penetrating steam produced by the Water Tank. • The Water Tank (2) is the reservoir where water is held before being transferred to the heat exchange and converted to steam. The Water Tank holds 8.8 oz. (260.2 ml.) of water. • The Handle (3) is engineered to stay cool while providing maximum grip and comfort. • The Power Light Indicator (4) illuminates red when the Unit is heating and will illuminate green when the unit is ready to produce steam.
Using Your Handheld Fabric Steamer FILLING TANK WITH WATER 1. Place Handheld Fabric Steamer on a flat, level surface. 2. Make sure power cord is unplugged from electrical outlet. 3. Remove Water Tank by grabbing on to ribbed sides and pulling out, see Figure 1. FIGURE 1 4. Remove rubber cap from top of Water Tank and fill with water from a faucet, bottle or cup. Follow marked Max and Min lines on Water Tank. Do not underfill or overfill Water Tank.
FABRIC STEAMING CAUTION: When steaming any material for the first time, it is recommended that you test on a small inconspicuous area before proceeding. Do not use on synthetic fabrics such as 100% nylon or polyester, or other steam-sensitive materials. NOTE: Be sure that Tank has already been filled before following these steps (refer to Page 6 for details). 1. Plug power cord into a standard grounded electrical outlet. 2.
Storage & Care PROPER STORAGE Preparing your Handheld Fabric Steamer for storage is quick and simple. When you have completed your tasks, follow the steps listed below. 1. Push the Power On/Off Switch (Power Indicator Light will turn off) and unplug power cord. 2. Allow unit time to cool (at least 30 minutes). 3. Remove Water Tank and drain any remaining water into a sink or tub to minimize potential mineral build-up. Replace Water Tank when done. 4. Store Handheld Fabric Steamer in a cool, dry location.
Troubleshooting PROBLEM Unit fails to heat up. Power Indicator Light DOES NOT illuminate. POSSIBLE CAUSE SOLUTION Unit is not plugged in. Plug power cord into electrical outlet. The Power Switch is pressed Off. Make sure the Power Switch is pressed to turn the unit On and Power Indicator Light is illuminated. Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault interrupter, or replace fuse.
Warranty Information 2-YEAR LIMITED WARRANTY What is covered Steamfast, a division of Vornado Air, LLC (“Steamfast”).
Steamfast 1-800-711-6617 415 East 13th, Andover, KS 67002 steamfast.com consumerservice@steamfast.
