Technical Specifications

Control Panel
middle control
cable
Steam Generator
Installation instruction of controller
Before installing the controller, make sure the steam generator is shut off
otherwise the controller may lose control or be damaged.
Step one
Determine the installation location of the controller.
The controller is designed to be installed in the steam
room only, and while installing:
1.4-5 feet from the ground.
2.Keep away from the steam nozzle and do not expose
under the direct spray of steam.
3.Install in the perpendicular wall.
4.The position of installation should facilitate easy
operation and convenient wiring
The controller wire is 1.6 feet long with a controller
lengthened wire of 20 feet long at the most. In the
installation of controller, it should be in a position not
more than 21 feet from the steam generator. If a longer
wire is needed, contact professional service personnel.
Do not install the controller under the
water pipe or in a position where water comes usually.
Step two
Drill a round hole of 1.378 inches in diameter in a
chosen position, no larger or smaller.
Step three
Pull the controller wire through the round hole,
connect it to the lengthened wire and then to the steam
generator and connect with the corresponding wire in
the generator. When the computer wire is plugged in,
aim at the direction and insert horizontally instead of
shaking left and right in case the computer needle
should be damaged. Do the same when plugging out.
Do not pull tight, fix tight or clip the
controller wire in case of damage to it.
Step four
Start the power supply of steam generator, check and
adjust connection, check each item on 3-4 page to
make sure all functions may work well.
Before fixing the controller, make sure
the steam generator is shut off otherwise the controller
may lose control or be damaged.
!
Important:
!
Important:
!
Important:
!
Important:
Page 2
GS08A