Installation Guide
Rev1/2015 
13 | P a g e  
 Chromatherapy 
This button controls the color of the Chromatherapy LED lights (picture 5). When the Chromatherapy function starts, the lamp symbol 
on the LCD display flashes. 
Circulation Fan 
This button turns fan on/off. When fan is turned on, the fan symbol on the LCD display Flashes. 
Steam on/off 
This button turns the steam on/off. Touching this button makes the steam symbol on the LCD display flash. The temperature sensor 
regulates  steam  output  based  on  the  preset  steam  temperature.  The  steam  generator  has  4°C  variance  between  accrual  set 
temperature and real temperature. 
Music on/off 
This button turns music on/off. 
FM Radio on/off 
Touch this button, and the radio station will show on the display. The FM radio is now on. The radio frequency by default is the same as 
the radio frequency selected last time. 
Note: if the MP3 shows on the display the radio will not play.  Touch the FM radio button again. 
Volume & Frequency Adjust 
  Volume 
Touch this button when the FM radio is on. Push to adjust the volume. Display will show DB. 
  Frequency 
Touch this button when the FM radio is on. Push the [ again to adjust the frequency. Display will show MHZ. 
Channel Memory 
  Channel Memory Setting: 
o  Start FM Radio 
o  To set your favorite station, press   button to desired memory position 1-8; set the desired station then press and 
hold   button for 5 seconds. The display will shift and memory will be saved 
o  Adjust FM Radio to your favorite channel; touch   button to adjust frequency and volume. 
o  Channel Memory:  Touch    button  for  more  than  3 seconds;  the  figure shows +1  and  turns  to original setting 
station number. Release button to finish setting for one channel.  If the station number is used for another channel, 
this channel will be replaced by the new channel in memory. 
o  Repeat the above steps to save channels in memory. Maximum 8 channels can be memorized. 
  Find Channel: 
o  Start FM Radio. Touch   button to find right channel in memory. 
  + adjust 
  - adjust 
o  The above 2 buttons are used to adjust frequency and volume. 










