Installation Guide

Rev1/2015
10 | P a g e
Turn on the water and test. Of the unit still leaks, replace the
cartridge (E).
 Make sure that both hot and cold water inlets are turned
on.
 Water flow is very low.
Check the cartridge assembly (D), for debris. Sediment where
the water enters the shower head (G) can also cause this
symptom.
 Water starts out hot and becomes cooler as handle is
rotated counter clockwise.
This is a potentially hazardous situation and should be corrected
before using the unit. Check the hot and cold inlet positions (hot-
left, cold-right). If you have a back to back installation, (where hot
and cold inlets are reversed) refer to valve body instruction sheet
for back to back installation.
 Water flows from the shower head while filling the tub.
Check the position of the valve body (J). The letters SHWR
should be vase into the top and TUB on the bottom.
 Water doesn’t get hot enough.
Remove hand (A), sleeve (B) and flange (C) and then refer to
valve body instruction sheets for adjusting temperature range.
 Water flows from the tub spout while using the shower.
The seal inside of the diverter mechanism may have become
dislodged. The spout (H) may need replacement.
CLEANING CARTRIDGE
If temperature or flow does not remain constant, the cartridge
assembly (A) must be cleaned. Shut-off water supply. Remove
trip assembly (not shown). Remove screws (C), backup plate (B)
and cartridge assembly (A). inspect inlets for sediment and flush
with water. Inspect O-rings (D & E) for damage. Re-install
cartridge assembly (A) and backup plate (B) then turn on water
supply. If the problem persists replace cartridge assembly (A).
CAUTION: Do not disassemble cartridge (A).
CLEANING AND MAINTENANCE FOR ALL UNITS
1. Liquid detergents and soft cloth should be used. Do not use any
abrasive cleaners.
2. The scale on the surface can be cleaned with a soft cloth and
nonabrasive cleaner or heated vinegar.
3. After every 30 uses, we suggest you to clean the steam generator.
We advise the use a filtration system for the steam generator unit.
One Compatible filtration system option is the -Whirlpool WHKF-DWHV
STEAM GENERATOR CLEANING FOR ALL UNITS
Remove the cover of the cleaning liquid inlet and pour in
approximately 1L of citric acid or white vinegar. Start the steam
function to fill the steam generator with water. Stop the steam
function before the steam starts to come out (“acidic” steam is
damaging to plated fixtures). Do not shut off the main power. The
scale in the steam generator dissolves and the system drains the
dirty water out after 60 minutes.
GENERAL USE AND MAINTENANCE FOR ALL UNITS
A. Drops of water will continue to drain out from the jets and water outlets after use, this is normal and it will eventually stop.
B. Abrasive cleaners must not be used.
C. Always shut off the power supply when the system is not in use.