Installation Guide

7
9. Electrical Connections: The wires for the fan, speaker, and
light are labeled. Make the corresponding connections
from the accessory to the wire coming from the control
box. *Note: Be cautious when making this connection. The
pins of the connector can easily bend if connected
improperly!
A: Wire for control panel
B: Temperature Sensor
C: Wire for
speaker/fan/light
D: Speaker
E: Fan
F: Lights
G: Connecting terminal
for light/fan/speaker
H: Control panel
connecting terminal
10. Water Connections:
Connect the rainfall
showerhead water line
to faucet, screw in. Also,
connect the light, fan and radio. Then locate the middle
water pipe, which is under the faucet, and connect it to the
steam box water inlet. Secondly, connect the black foam
steam line, which is on the side of the steam box, to the
steam outlet. Connect steam box drain line to the steam
outlet drain. Finally, connect the cold and hot water lines
to the water manifold, the red one is for hot water, while
the blue is for cold.
A: Steam outlet
B: Black steam hose (insulated)
C: Diverter
D: Rainfall shower head supply
11. In the box that contains the electronic components, there
is a grey hose with a “T” and three ends. This is the drain
system for the steam generator. Its connection is as
follows. One end of the hose is connected to the steam
generator where it is labeled steam generator drain, the
second end is connected to the small plastic stub sticking
out the glass panel right below the steam line connection
and the third and last connection of the hose goes the 90
degree barbed fitting about 6 inches below the steam
outlet.
12. Attach glass panel E which has a black stripe across the top
and side to glass panel D and A. Note: On the front panel E
there is a “notch” on the bottom. It is imperative the notch be
moved as far as the base will allow; this should give you an
overhang of the side panel over the base about 1/8 to 3/16 in.
If you do not have the glass positioned with the overhang
there will not be enough space between the door and the side
panel to enable the magnetic strips to make proper contact.
13. Place glass C into the slot onto the base and insert into the
corner seal of glass B. Note: Glass C is the clear panel, and
glass B is a black/white large solid panel. Line up the
installation holes and connect glass B and glass C. Note: Use
Windex for lubricant.