Installation Guide

8
labeled steam generator drain, the second end is connected to
the small plastic stub sticking out the glass panel right below
the steam line connection and the third and last connection of
the hose goes the 90 degree barbed fitting about 6 inches
below the steam outlet.
16. Attach glass panel E which has a black stripe across the top
and side to glass panel D and A. Note: On the front panel E
there is a “notch” on the bottom. It is imperative the notch be
moved as far as the base will allow; this should give you an
overhang of the side panel over the base about 1/8 to 3/16 in.
If you do not have the glass positioned with the overhang there
will not be enough space between the door and the side panel
to enable the magnetic strips to make proper contact.
17. Insert the corner seal and corner brackets on the left side of
glass F (will have holes for door hinge) attach to panel D & C
with angle brackets and connector bolts. Attach door hinges
and door Panel G.
Note: Read the Door Installation Help on page 9.
18. Put the wood floor grids in the shower tray and benches in the
unit. Attach flexible waterline to outlet on panel A and the other
end to the handheld shower wand. Attach to the bracket. Note:
the hex nut of the water line goes on the panel outlet.
19. Attach handle to the door and shelves to panels B and C.
20. This gasket must go between the magnetic gasket and the
bubble gasket on the hinge side. The magnetic gasket
and bubble gasket must extent down to almost touching
the base top otherwise there could be some leaking.
21. Steam Cup Connection Diagram
A: Steam outlet
B: Steam line
Connector
C: Glass
D: Steam hose