Installation Guide

7
9. Install angle brackets over the installation holes of glass A,
connect with connector bolts (make the connection snug, but
loose enough to make adjustments.)
10. Place bottom edge of glass A into the slot on the base as
shown. A small amount of soap or lubricant on the gaskets
will help with installation.
11. Assemble the half-moon shaped seals on the sides A, and C
of glass D (top), if needed. See illustration below. Attach
angle brackets to glass panel D. Note: The fan and speaker
side of the glass will hang over the main control panel.
12. Place glass D (top) on the top of the unit, align connecting
holes with glass D to glass panels A, B, and C. Use
connector bolt to connect. Please refer to illustration
below.
13. Electrical Connections: The wires for the fan, speaker, and
light are labeled. Make the corresponding connections
from the accessory to the wire coming from the control
box. *Note: Be cautious
when making this
connection. The pins of
the connector can easily
bend if connected
improperly!
A: Wire for control
panel
B: Temperature
Sensor
C: Wire for
speaker/fan/light
D: Speaker
E: Fan
F: Lights
G: Connecting terminal for light/fan/speaker
H: Control panel connecting terminal
14. Water Connections: Connect the rainfall showerhead
water line to faucet, screw in. Also, connect the light, fan
and radio. Then locate the middle water pipe, which is
under the faucet, and connect it to the steam box water
inlet. Secondly, connect the black foam steam line, which
is on the side of the steam box, to the steam outlet.
Connect steam box drain line to the steam outlet drain.
Finally, connect the cold and hot water lines to the water
manifold, the red one is for hot water, while the blue is for
cold.
A: Steam outlet
B: Black steam hose (insulated)
C: Diverter
D: Rainfall shower head supply
15. In the box that contains the electronic components, there is a
grey hose with a “T” and three ends. This is the drain system
for the steam generator. Its connection is as follows. One end
of the hose is connected to the steam generator where it is