Installation Guide

PFISTER HANDLE ASSEMBLY

TRIM FLANGE ATTACHMENT

Position Flange (A) on the Valve (B) with drain hole (C) at the

bottom. Place Protective Washer (D) on the short end of the

reversible Retainer Sleeve (E). Screw Retainer Sleeve (E) onto

threaded section of the Stem and Bonnet (G). Tighten Retainer

Sleeve (E) by hand until Flange (A) is snug to finished wall surface.

If the short end of the Retainer Sleeve (E) is too short, reverse it to

use the longer end.

HANDLE ATTACHMENT

Screw Stem Extender (A) onto the Valve Stem (B). Thread the Set

Screw (C) into the Handle and thread it in only three or four turns.

With valve in CLOSED position, place handle (D) onto the Steam

Extender (A) and tighten the Set Screw (C) by using the Hex

Wrench (E) that is provided.

Note: Make sure Set Screw (C) is securely tighten to handle (D).

TEMPERATURE ADJUSTMENTS

Adjustment gear (A) is factory-set to prevent stem from reaching

full hot position. To adjust stem rotation: remove adjustment gear

(A). Rotated steam (B) counterclockwise to determine a

maximum desired temperature. Replace gear aligning

adjustment stop (C) to stem tab surface (D) to stem (B) cannot

move beyond adjustment point.