Instructions / Assembly

Page 17
DVR MODE: This setting allows you to
continuously record new images. Turning this
setting ON will continuously delete oldest recorded
les to make space for new les. When turned
OFF, the camera will stop recording new les when
SD card reaches capacity.
OPTIONS: On | O󰀨
TEMPERATURE: This setting is used to change
temperature format on Info Bar.
OPTIONS: Fahrenheit | Celsius
LONGITUDE and LATITUDE: This setting allows you
to manually enter the longitude and latitude of your
camera.
OPERATING HOURS: This feature allows you to
designate a time for the camera to be active.
OPTIONS:
24/7: Camera is always on
SCHEDULED: Selecting this will allow you to
enter a time range for the camera to be active
and operational. Camera will not take photos
outside of dened time range.
START TIME (HH:MM): Start time for
camera to be active
END TIME (HH:MM): Time at which you
want the camera to no longer be active
INFORMATION BAR: This setting is used to
tell the camera whether the Info Bar should be
displayed at the bottom of images.
OPTIONS: On | O󰀨
ERASE CARD: This setting is used to format the SD
memory card installed. Formatting your SD card will
ERASE ALL DATA PRESENT.
NOTE: After card is formatted it is impossible to
restore data that was present on card.
VIDEO LENGTH: This setting is used to determine
the length of time, in seconds, of a video recording.
Video records for 10 seconds.
VIDEO AUDIO: This setting will determine if the
video records with or without audio. Recording audio
with each video will take additional memory space.
OPTIONS: O󰀨 | On
TIME LAPSE (TL) DELAY: This setting will adjust
the length of time between each photo taken during
the time lapse.
OPTIONS: 00 min 05 sec - 59 min 59 sec
TL START: This setting is used to determine the start
time of the time lapse.
TL STOP: This setting is used to determine the end
time of the time lapse.