User's Manual

STC-I540IR

www.stealthcam.net Toll Free 877-269-8490

Using the Camera in PIR Detection Mode

• Mount the camera to a tree or other sturdy object using either

the supplied mounting strap. (Please refer to the mounting

suggestions section in this manual)

• Open the front housing and slide the Toggle switch from OFF

to TEST position. You will hear two short consecutive beeps

followed by a third beep.

• Move the switch from Test to ON position to activate your PIR

mode.

• The camera’s green LED light will begin blinking and enter

count down mode. This is your indication to leave the coverage

area within one minute.

• After one minute, the camera will take between 1~9 pictures, or

AVI video clip based on your program settings. The camera will

then time out between 1~60 minutes also based on your

selection.

 The time between motion detection and the camera taking

pictures may vary due to lighting and environment

conditions, program settings and battery power level.