Instructions / Assembly

"""#$%&'(%)*'+#*,+! -'.&!!!
/0012341/546!
EE!
*0!$50';5",50!!1/,'+'*4()"!'8*"/)9
o PIR)PHOTO (default): In!this!mode!the!camera!will!take!a!designated!amount!of!picture!with a!
designated! time! out! when! the! camera! senses! activity! in! front! of! the! unit.! ! This! mode! adjusts
for!both!day!and!night!activities.!
" PHOTO DAY PHOTO RES – 8.0 (default): This setting is used to determine the Megapixel resolution of
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 32MP, 16MP, 8MP, 4MP Day resolutions The higher the resolution of an
image the more space the fie will take on the SD memory card.
" NIGHT PHOTO RES – 6.0 (default): This setting is used to determine the Megapixel resolution of each
image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 14MP, 8MP, 6MP, 2MP Night resolutions The higher the resolution of an
image the more space the fie will take on the SD memory card.
" PIR'DELAY'–'00min'05sec (default):!!This!setting!is!used!to!determine!the!length!of!the!time!that!the!
camera!will!wait!before!it!reinitializes!its!PIR!sensor!for!the!next!activation.!!With! the!TL!mode!this!
setting!is!only!active!if!TL!Delay!is!set!to!1!min!or!greater.!!This!setting!can!be!changed!between!the!
numbers! of! 00min! 05sec! to! 59min! 59sec.!! With! this! option! blinking,! use! of! the! UP! and! DOWN
arrows! will! allow! the! minutes! setting! to! be! changed! from! 00! to! 59.!! Once! this! setting! is! on! the!
appropriate! minutes,! press! the! RIGHT! arrow! key! to! move! to! the! seconds! setting! and! it! will! start! to!
blink.!!Use!of!the!UP!and!Down!arrows!will!allow!the!seconds!setting!to!be!changed!from!00!to!59!(05!
to!59!if!minutes!=!00).!
" PIR'RANGE'–'STANDARD!(default):!This!setting!allows!you!to!control!the!sensitivity!distance!the!PIR!
will!be!activated.!These!distances!can!vary!depending!on!environmental!conditions.!!This!setting!will!
change! between! EXTENDED! which! will! trigger! about! 1/3! further! than! the! STANDARD! setting,! the!
STANDARD!setting,!or!NEAR!FIELD!that!will!only!trigger!on!movement!closest!to!the!camera.
" IR Brightness Control – FULL (default): This setting is used to adjust the brightness of the IR LEDS.
With this option blinking, use the UP or DOWN arrow key to move between FULL and HALF brightness.
On FULL brightness the LEDs have a further flash range making it ideal for large open areas. HALF
brightness is ideal for close up shots preventing the subject from being overexposed.