User's Manual

UM000004-1_3 - Micro.sp (Q)Be © Station System v4 User Manual
14
Ste Industries
Via privata Oslavia 17/8D – 20134 Milano
www.ste-industries.com – [e-mail]
Switch 1 Switch 2 Installation
On On Address 0 (default)
On Off Address 1
Off On Address 2
Off Off Address 3
DIP switch SW7 is equipped only on Master unit and defines the number of Slave units present in
the system. At present only the default configuration (one Slave) has been tested and released.
Switch 1 Switch 2 Configuration
On On No slave units, Master only
On Off One slave unit (default)
Off On Two slave units
Off Off Three slave units
2.1.6 SIM card installation (only on Master tower)
Note
: SIM card is not included in (Q)Be© product content, it must
be provided by the customer.
SIM card shall be installed in the mother board of (Q)Be© master tower. A Nano SIM card is
required.
To install the SIM card, remove the SIM card tray from the holder, then place the card on the
tray and slide it towards the holder (as shown in the figure below) until it is inserted
completely. You may need a small tool (e.g. pincers) to help pushing the card inside.
Figure 9 – SIM card insertion