Instruction Manual

WPS-750-BUL-AH Installation Manual

1. Prepare Camera for Mounting

Prior to mounting to the Camera, we recommend that the position and

anglesbepresetinordertospeedinstallation.Thesesettingscanbene-

tuned once the Camera is mounted.

A. Adjust Camera Rotation

B. Adjust Swivel of Camera

C. Adjust Camera Angle

2. Connect the Camera to the System

Recommended Cabling:

- Video RG59 or RG6

- RS485 OSD Control Cat5e/6

- Power 18/2 or Cat5e/6

Important Note! Be sure to use the correct power supply

and power wire for the length of run to the camera to

ensure reliable operation. Too small a power supply or

wire will cause too much voltage drop, which will cause

the camera to operate incorrectly or not power up at all.

12V DC

Power In

BNC

Video Out

RS485 Leads

A. Connect the BNC video output to

the video in of a DVR or monitor.

B. Connect the DC Power In to a

12V DC-24V AC 1A power supply

using the included WPS-ACC-PWR

power adapter. The power supply

can be located at the head end

of system using a WPS-PS multiple

output power supply and prewiring a

power wire.

INSTALLATION INSTRUCTIONS