Instruction Manual

WPS-750-BUL-AH Installation Manual

The 3D-DNR function cannot be set to ON

 •CheckifAGCissettoOFF.WhenAGCisOFF,3D-DNRcannot be

activated.

The color of the picture is not correct

 •CheckWhiteBalanceandColor(Red/Blue)settings.

 •Resetthecameratofactorydefaultsettings.

Screenickerscontinuously

 •Checkthecameralocationtomakesureitisnotpointing

directly towards the sun or bright light source.

 •Checkiftheickerlesscontrolissetcorrectly;propersettingsshould

reectrequiredrefreshrates.

 •Resetthecameratofactorydefaultsettings.

RS-485 communication failure

 •CheckwhethertheRS-485polarityisconnectedcorrectlyto

the RS-485 port.

 •ChecktheCameraIDsettingandmakesurethereisnot

more than one device with the same ID on the RS485 network.

 •CheckthattheProtocolandBaudRateforalldevicesareset

  tothesameconguration.

• Warning:ConictingsettingsoftheProtocolandBaudRateamongdevicesconnected

to the RS485 network could result in abnormal operation of the camera. Ensure that the

ProtocolandBaudRateforalldevisesaresettothesameconguration.

OSD Menu appears randomly without prompt from user

•Check the Pigtail - Verify that the pigtail is not pinched.

•SecureRS485Wiring-VerifythattheRS485wiresarenottouchingor

shorting on a metal box.

Condensation Appears on Camera Lens Cover

• Check the color of the beads in the Silica pack under the lens cover.

 •Ifthebluecrystalshaveturnedpinkindicatingthatthepackhas

absorbed moisture, replace the pack with the spare provided with

the camera.

Camera Power Cycles Intermittently

• Check voltage at camera for proper voltage level.

•Connectcameralocallywithadifferentpowersupplytotest.