User Manual
6
WPS-500-BUL-A Installation Manual
3. Use the provided template on
page 27 to pre-mark mounting
hole locations. Position the camera
base at the desired location and
use the provided screws to attach
the camera base to the wall
or ceiling.
4. Using the supplied AC/DC plug,
connect the power supply jack
to 12-30V DC or 24V AC
and the BNC Video Output to
the desired video line.
INSTALLATION INSTRUCTIONS
SET-SCREWS
12-30V DC
or 24V AC Power
BNC Video Output
RS485 Leads
White (+), Green(─)
AC/DC Plug
1. Recommended cabling includes solid copper RG59 or RG6 for
video, 18AWG two-conductor for power, and a CAT5 for RS485
control of the OSD.
2. Prior to installation, it is recommended to pre-adjust the camera’s
bracket angle so the lens points in the desired direction. It is also
recommended to connect the camera to a display and pre-
adjust the zoom and focus (see step 5). If the RS485 function will be
utilized,congureandtestthesettingspriortocameraplacement.
Taking these steps will speed installation time.