User Manual

24
WPS-500-BUL-A Installation Manual
The color of the picture is not correct
 •CheckWhiteBalanceandColor(Red/Blue)settings.
 •Resetthecameratofactorydefaultsettings
Screenickerscontinuously
 •Checkthecameralocationtomakesureitisnotpointing 
directly towards the sun or bright light source
 •Checkiftheickerlesscontrolissetcorrectly;propersettings
  shouldreectrequiredrefreshrates.
 •Resetthecameratofactorydefaultsettings
AGC settings are not available
 •DAY&NIGHTModeissettoAUTO.ToenableAGCcontrol 
change DAY&NIGHT to EXT, Color or B/W
RS-485 communication failure
 •CheckwhethertheRS-485polarityisconnectedcorrectlyto
the RS-485 port.
 •ChecktheCameraIDsettingandmakesurethereisnot
more than one device with the same ID on the RS485 network.
 •ChecktheProtocolandBaudRateforalldevicesareset
  tothesameconguration.
•Warning:ConictingsettingsoftheprotocolandBaudRate
among devices connected to the RS485 network could result
in abnormal operation of the camera. Ensure that the Pro-
tocol and
BaudRateforalldevicesaresettothesameconguration.
OSD Menu appears randomly without prompt from user
•CheckthePigtail-Verifythatthepigtailisnotpinched.
•SecureRS485Wiring-VerifythattheRS485wiresarenottouchingor
shorting on a metal box.
Condensation Appears on Camera Lens Cover
•CheckthecolorofthebeadsintheSilicapackunderthelenscover.
•Ifthebluecrystalshaveturnedpinkindicatingthatthepackhas
absorbed moisture, replace the pack with the spare provided with
the camera.