Owner's manual

25
WPS-550-BUL-A Installation Manual
© 2013 Wirepath Surveillance
TROUBLESHOOTING
Ifyouhavetroubleoperatingthecamera,rstrefertothefollowing
guidelines. If the problem persists, contact Technical Support
at 866.838.5052.
Nothing appears on the display
 •CheckifthepowerforcameraandmonitorisON.
 •CheckiftheVIDEOcableisconnectedtothecamera
BNC video output jack.
 •CheckiftheVIDEOcableisconnectedtothemonitor
VIDEO input jack.
Image appears dim on the display
 •Checkthemonitorcontrastsetting.
 •Checkthemonitorandcamerabrightnesssetting.
 •Checkthecameraexposureandshuttersettings.
 •Checkthelens.Ifnecessary,cleanwithasoft,cleancloth.
 •Checkifthecameraisfacingtowardsabrightlight.Ifso, 
change the camera position.
 •Ifadeviceexistsbetweenthecameraandscreen,conrm
the signal accepted by the screen is strong enough – 75 Ohm.
 •Resetthecameratofactorydefaultsettings.
Image appears blurry on the display
 •Checkthefocusofthelens.
 •Checkthelens.Ifnecessary,cleanwithasoft,cleancloth.
 •Checkthecamerairisandshuttersettings.
 •Resetthecameratofactorydefaultsettings.
The camera is not working properly and the camera housing is hot
 •Checkifcameraisconnectedtothecorrectpowersource.