Manual

INSTALLATION INSTRUCTIONS
Step1:UseCeilingPlatetoMarkMountingHoleLocations(Low-ProleorExtension)
a. Theuseofastudnderishighlyrecommended.WhenmountingtheLow-ProleCeilingPlate,
  makesurearrowonbottomoftheLow-ProleCeilingPlatefacestowardthescreen.
Step2:MounttheCeilingPlate
Low-Prole Ceiling Plate
For Mounting on a Wood Joist (Fig. 1)
 a.Pre-drilltwoholesintojoistusinga3/16”drillbit.
Be sure to drill into the center of the joists.
 b.InserttwoLagScrewsintoholesthroughthe
  Low-ProleCeilingPlateandtightendown.
 WARNING:TightenscrewssothattheLow-Prole
CeilingPlateisrmlyattached,butdonotover-
 tighten.Over-tighteningcandamagethescrews,
greatly reducing their holding strength.
For Mounting on a Concrete Ceiling (Fig. 2)
a. Pre-drill two holes into concrete using 3/8” Masonry bit. Insert Concrete Anchors and
tap in with hammer, if necessary.
  WARNING:WheninstallingCeilingPlateoncinderblock,rstverifythereisaminimumof1-3/8”
of concrete thickness to be used for the Concrete Wall Anchors. Do not drill into mortar joints!
  Besuretomountinasolidpartoftheblock,generally1”minimumfromthesideoftheblock.
  CinderblockmustmeetASTMC-90specications.Itissuggestedthatastandardelectricdrillonslow
  settingisusedtodrilltheholeinsteadofahammerdrilltoavoidbreakingoutthebackofthe
  holewhenenteringavoidorcavity.
  Concretemustbe2000psidensity
  minimum.Lighterdensityconcrete
may not hold concrete anchor.
Make sure that the supporting surface
will safely support the combined load
of the equipment and all attached
hardware and components.
 b.InserttwoLagScrewsintotheConcrete
  AnchorsthroughtheLowProleCeilingPlate.
WARNING:TightenscrewssothattheLow-Prole
  CeilingPlateisrmlyattached,butdonotover-
  tighten.Over-tighteningcandamagethescrews,
greatly reducing their holding strength.
Extension Ceiling Plate
For Mounting on a Wood Joist (Fig. 3)
a. Use Extension Ceiling Plate to mark two hole locations.
  Pre-drilltwoholesintojoistusinga3/16”drillbit.Besure
to drill into the center of the joists.
 b.InserttwoLagScrewsintoholesthroughtheExtension
Ceiling Plate and tighten down.
  WARNING:TightenscrewssothattheLow-ProleCeiling
  Plateisrmlyattached,butdonotover-tighten.Over-
tightening can damage the screws, greatly reducing their
holding strength.
 c. ThreadExtensionPole(ULListedSM-FIXPOLEseries,notincluded)
  intoExtendedCeilingPlate.LockpoleinplacewithtwoM5setscrews.
 d.OnbottomofExtensionPole,threadonLow-ProleCeiling
Plate, making sure the arrow (on bottom) faces the screen
when installed. Tighten Security Screw (pre-installed) to lock
  Low-ProleCeilingPlateontoExtensionPoletosetinplace.
#14x2.5”
LagScrew(x4)
#14x2.5”
LagScrew(x4)
ExtensionCeilingPlate(x1) ExtensionPlateCover(x1)
M3x8 Socket
Screw, security (x4)
Low-ProleCeiling
Plate(x1)
Projector Mount
Body(x1)
M4x10Socket
Screw, security (x4)
M5x10Socket
Screw, security (x4)
M6x10Socket
Screw, security (x4)
10-32X10Socket
Screw,security(x1)
10x50Concrete
Anchor (x4)
4mm (ID) Washer
(x4)
4mm (ID) Washer
(x4)
M5x5 Set Screw,
security/non-security
(x2/2)
2mmAllenWrench,
security(x1)
2mmAllenWrench,
security(x1)
4mm Allen Wrench,
security(x1)
HARDWARE KIT
SPECIFICATIONS
 •Maximumload:50lbs(22.68kg).
 •Tiltrange:+/-25º
 •Roll:+/-6º
TOOLS REQUIRED
 •PhilipsHeadScrewDriver
 •PowerDrill
 •3/16”(5mm)DrillBit
 •3/8”(10mm)MasonryBit
 •StudFinder
 •10mmor3/8”Socket
Head Wrench
WARNINGS
 •Wehighlyrecommendthisproductbeinstalled
  byaqualiedprofessional.
 •Donotbegininstallationuntilyouhave 
thoroughly read and understand these instructions.
 •Thismountsupportsprojectorswithamaximumload
  of50lbs(22.68kg).
 •Ensuretheceilingwillsafelysupportfourtimesthe
combined weight of the mount and projector.
 •Undernocircumstancesshouldthisproduct
be mounted to metal studs.
 •Themanufacturerdoesnotacceptresponsibility
for incorrect installation.
MAINPACKAGECONTENTS
EXTENSIONPLATECONTENTS
Fig1
Fig2
Fig3
CAUTION:
This mount is intended for use only with
themaximumweightof50lbs(22.68kg).