User guide

B-500-MTRX-230-8x8 Installation Manual
Pg. 12
© 2013 Binary
™
7.8. IR Pass-Through Installation and Setup
ToutilizeIRpass-throughbetweenadisplaylocationandthematrixswitcher,installaB-500-RX-230-IRatthedisplay
anduseHDBaseTforroutingthesignal.Thematrixswitcherandthematrixreceiverareequippedwithportstoallow
commandstobesenttothedisplayorfromthedisplayarea.ThissectiondetailsthepinoutsandcorrectuseoftheIR
pass-through ports.
7.8.1. Matrix Switcher IR Connections
Theportsindicatedinthediagramaredescribedindetailbelow.Guidesforstandardapplicationsareincludedonthe
followingpagesforreferenceduringsetup.
7.8.2.MatrixSwitcherIRPortConguration
AllIRconnectionportsontheB-500-MTRX-230-8X8are3.5mmmonominiandusethispinoutconguration.Consult
withthemanufacturerofanyattachedIRequipmenttoconrmtheirpinoutmatchesbeforeuse.
1. IR Input to Room 1 through 8
Use3.5mmmini-monocablestoconnectIRasheroutputsonacontrolsystemtotheseportstosendcommands
todisplaysorequipmentlocatedattheB-500-RX-230-IRmatrixreceiverlocation.Thenumbercorrespondstothe
outputzonenumber,soIRInputtoRoomport1willsendsignalstoHDBaseToutput1.
2. System IR In
 3.5mmmonominiIRinputportformatrixswitcherIRcontrol.
3. System All IR Out
 ThisportrepeatsanycommandsentfromtheIRReceiverportsonB-500-RX-230-IRMatrixReceiversconnected
to any HDBaseT output.
4. IR Output to Source 1 through 8
 TheIRoutputfromeachconnectedB-500-RX-230-IRistransmittedtotheIROUTPUTTOSOURCEports.
Commandscanberoutedtothesourceselectedortothelike-numberedport.
LINK LINK
PWR
LINK LINK LINK LINK LINK LINK
Engineered in the USA
Manufactured in Taiwan
IR IN
ALL IR OUT
1 2 3 4
IR Signal (Tip)
GND (Sleeve)
IR Signal Tip
GND (Ground) Ring