OWNER’S MANUAL B-300-HDMATRIX-RCVR BINARY SINGLE CAT 5E/6 HDMI 1.
B-300-HDMATRIX-RCVR Installation and Users Manual IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus in or near rain or moisture. 1. Read and follow all instructions and warnings in this manual. Keep for future reference. 2. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers). 3. Do not install the unit near water or where moisture is present. 4. Clean with a dry cloth. 5.
B-300-HDMATRIX-RCVR Installation and Users Manual FEATURES • Support for HDMI 1.4a 3D formats • Extends the transmission up to 200 ft. from the HDMI source at HD 1080i or 720p 24-Bit • Extends the transmission up to 130 ft. from the HDMI source at Full HD 1080p 24-Bit • Extends the transmission up to 65 ft. from the HDMI source at Full HD 1080p 36-Bit • HDCP 2.
B-300-HDMATRIX-RCVR Installation and Users Manual BASIC CONNECTIONS B-300-HDMATRIX-4x4 Cat5e/Cat6 (Shielded Recommended) IR Receiver B-300-HDMATRIX-RCVR HDTV IMPORTANT CONNECTION NOTES! HDMI cable (1m max length) • CAUTION: The IR Receiver 3.5mm jack provides 12V power for IR receivers that can damage flashers and control systems. Check carefully before plugging an IR Flasher or IR Receiver into the respective IR sockets. Manufacturer’s Warranty will not cover the damage.
B-300-HDMATRIX-RCVR Installation and Users Manual IR PASS-THROUGH Bi-directional IR signals are also transmitted between the B-300-HDMATRIX-RCVR and the B-300HDMATRIX-4x4 or B-300-HDMATRIX-8x8 switchers over the Cat5e/6 cable. Each B-300-HDMATRIX-RCVR will need an IR Receiver to send IR from the RCVR to the switch, and an IR flasher to use IR sent from the switch to the RCVR (sold separately). IR Receiver HDTV NOTE: This product was specifically engineered for Episode® IR products.
B-300-HDMATRIX-RCVR Installation and Users Manual CONNECTING A CONTROL SYSTEM OR IR CONNECTING BLOCK When connecting a control system or connecting block to the IR Receiver jack, the 12V DC (Sleeve) must not be connected. Connections of this type require the use of the included Stereo to Mono IR Adaptor or a custom cable made. A mono 3.5mm cable should not be used as it will short out the 12 VDC to GND and will make the connection inoperable.
B-300-HDMATRIX-RCVR Installation and Users Manual SPECIFICATIONS Technical HDMI Compliance HDCP Compliance Video Bandwidth Video Support HDMI over UTP Transmission (24-bit) Audio Support Distance Control Signal Input HDMI Output IR PassThrough Type: Carrier frequency: IR Receiver IR Flasher Mechanical Housing Dimensions (L x W x H) Weight Power Supply Power Consumption Operation Temperature Storage Temperature Relative Humidity Certifications Full HD 1080P60, Deep Color (36bit), 3D (1.
© 2011 Binary 111215
