User manual

switching power supply

type 3656.1

The connection and business of low voltage consumers with an operating voltage between 0 and 30 V direct

voltage. The current consumption of the consumer mustn't exceed 66 amps.

Respect! Read absolutely!

These read through these instructions exactly. The right to claim under guarantee dies at damages which are caused

by no observance of the instructions. For resultant damages we don't assume any liability.

1. introduction for the switching power supply

This power supply unit is of tension with his direct one moving possibilities and current is universally usable for

industry, research and education.

An electronic current limitation protects the power supply unit from overload.

Output voltage is current electronically stabilized and directly adjustably and -- . The electronic current stabilization

can therefore be used to protect consumers from one to high current consumption as adjustable current limitation.

The output voltage then becomes at an overload according to drop (at short-circuit on near 0 V). This one

overlooked at elimination the before oriented output voltage automatically again. One becomes the respective work

condition, tension, (cv) or current stabilization (cc) LED reported by ever.

The oriented results are a 3 ½ digit LCD indication 13 mm readable over ever. The tension or current attitude carried

out about rough -- and fine-tuning control.

PAGE 1
switching power supply type 3656.1 The connection and business of low voltage consumers with an operating voltage between 0 and 30 V direct voltage. The current consumption of the consumer mustn't exceed 66 amps. Respect! Read absolutely! These read through these instructions exactly. The right to claim under guarantee dies at damages which are caused by no observance of the instructions. For resultant damages we don't assume any liability. 1.
PAGE 2
. Sicherheitshinweise 2.1 Die Sicherheit entspricht der DIN. Die Transformatoren entsprechen der DIN und sind primär/sekundär mit 3,75 kVeff geprüft. The power supply unit is built up in safety class I as well as in accordance with EN61010 und DIN EN 60950 . The net transformer is built up after EN 61558 as safety separating transformer and is checked with 3.75 kVeff primarily/secondarily.
PAGE 3
the piece of equipment or the power cord shows visible damages -the piece of equipment doesn't work -- any more -- after longer storage under unfavourable conditions after heavy transport uses 3. Operation 1 – Power switch 2 -- mass socket 3 -- rough u. fine tuning tension attitude 4 -- rough U .
PAGE 4
Technical data Operating voltage 230 V AC +10 / -10% Mains frequency 48 bis 62 Hz Current consumption max. 12A <0,98 Output voltage 0,01 ... 30,5V Output current 0,01 ....