User manual

Technical data

operating voltage: : 230 V AC +7/-5%

frequency: : 50 bis 60 Hz

power input: : max. 10 A

source 1 source 2

output voltage: : 0,005 .... 40 V 0,005 .... 40 V

output current:

: 0,003 ....10,0 A 0,003 ....10,0 A

voltage stability with +7/ -5% mains fluctuation: : < 1 mV < 1 mV

load compensating with 100% load change: : 3 mV 3 mV

current stability with +6 / -10 % mains fluctuation: : 1 mA 1 mA

remaining ripple with nominal load: : ca. 2mV

eff

bzw. 4 mA

ca. 2mV

eff

bzw. 4 mA

mains fuse: : 2x 4,0A T 2x 4,0A T

acting voltage display: : LCD with 3½ digits LCD with 3½ digits

current display: LCD with 3½ digits LCD with 3½ digits

weight: : ca. 23 kg

dimensions (B x H x T): : 451 x 134 x 410 mm

site conditions

operating temperature area: : +10 °C bis +35 °C

Air humidity: : max. 85 %

air pressure: : 800 bis 1333 hPa

Statron Gerätetechnik GmbH

Ehrenfried-Jopp-Straße 59

15517 Fürstenwalde

Tel.: (03361) 37 21 01

Fax: (03361) 37 21 03

e-Mail : statron@statron.de

Internet: www.statron.de

PAGE 1
Technical data operating voltage: : 230 V AC +7/-5% frequency: : 50 bis 60 Hz power input: : max. 10 A source 1 source 2 output voltage: : 0,005 .... 40 V 0,005 .... 40 V output current: : 0,003 ....10,0 A 0,003 ....10,0 A voltage stability with +7/ -5% mains fluctuation: : < 1 mV < 1 mV load compensating with 100% load change: : 3 mV 3 mV current stability with +6 / -10 % mains fluctuation: : 1 mA 1 mA remaining ripple with nominal load: : ca. 2mVeff bzw. 4 mAeff ca.
PAGE 2
Operating instruction lab power supply unit type 3262.1 The intended application of the power supply unit covers: - link and operation of low-voltage consumers with an operating voltage between 0 and 40 VDC. The power input of the consumer may not exceed 10,0 A. Note! Absolutely read! - Read this guidance exactly. With damage, which is caused by neglect of the guidance, the warranty claim goes out. For damages we do not take over adhesion. 1.
PAGE 3
2. Safety notes 2,1 the power supply unit is in safety class system I as well as in accordance with VDE 0411 and VDE 0805 (EN60950) structured. The supply transformer is structured and with 3,75 kVeff is primarysecondarily checked according to DIN VDE 0551 as safety insulating transformer. It is radio-screened in accordance with VDE 0875T11 curve B.
PAGE 4
3.