User manual

no longer possible if:
the piece of equipment or the power cord shows visible damages --
the piece of equipment doesn't work -- any more
-- after longer storage under unfavorable conditions
 after heavy transport uses
3. Operation
4. putting into operation are
a) connection
Plug the Euroschutzkontaktstecker of the power supply unit in to a safety contact electrical outlet 230 V/(50 hz) and
switch the power supply unit on about the power switch.
Respect!
With longer business with maximum current withdrawal (40 ares) or at short-circuit the cool body gets very warm in
the power supply unit. An overload of the power supply is reported to LED "excess temperature" by the red. The
exit data fall against zero simultaneously.
You pay attention therefore absolutely to a sufficient ventilation of the power supply unit the air leaving opening of
the coercive cooling and never conceal they the ventilation slits at the piece of equipment underside and at the
rear.
The availability of the maximum output current in the permanent operation immediately depends on an optimal
cooling and the surroundings temperature.
Take care at the connection of a consumer absolutely that this isn't attached in the condition switched on. A
consumer switched on can lead to a spark formation at the connection to the output terminals of the power supply
unit at the terminals which the ports or the attached lines and/or whose clamps can damage in turn.
The short-term mode of the piece of equipment is the LED (5) and (6) recognizable to.
b) presetting of maximum tensions and current exit results
You press in the condition of the power supply unit switched on without for attached consumer for the presetting
switch for "preset" .An the LCD-displays are readably the at the moment at most attainable exit results now directly.
The handicap results can by the adjust belonging Potentiometer to the desired application case to this.
Respect!
Follow the safety notes absolutely under section 2 of these instructions.
1 – Power switch
2 -- mass socket
3 -- rough u.Feinregler tension attitude
4 -- rough U . fine-tuning control current attitude
5 -- LED constant voltage business
6 -- LED constant current business
7 -- LCD indication tension
8 -- LCD indication current
9 -- output jacks+and-
10 -- LED excess temperature
11—preset switsch
12-- indications switch-selectable; one makes it
possible Presetting of the set points
13-- Carrying handle