User manual

3
2.11 Do not physically abuse the unit. Dropping it off a workbench or bouncing it around the trunk of a
car or the back of a truck may cause damage. Protect the unit while transporting it and use it where
it cannot be accidentally hit, kicked, or dropped.
2.12 If the unit fails higher voltages then set up can lie on the sockets. Switch off the unit in this case.
Remember that we can not be make responsible for damages caused by failing of the unit.
2.13 Do not use the unit if:
- there are visible damages,
- the unit do not work,
and
- after longer storing under bad conditions
or
- heavy transport hit the unit.
2.14 Electronic circuits do not mix well with water, chemicals, dust, or grid. Avoid exposing your
instrument to these or other contaminants. The case is not water- or air-tight. Do not place liquid
containers on or near the unit where they can be splled into it.
2.15 A series connection of several units is allowed only to a overall voltages of 1000V DC.
3. Control elements
1 Voltage Display
2 Current Display
3 Switch to display the max.
current.
4 Powerswitch
5 knob for voltage control
coarse
6 LED is lit when in constant
voltage mode
7 knob for voltage control
fine
8 knob for current control
coarse
9 LED is lit when in constant
current mode
10 knob for current control
fine
11 LED is lit when overloaded
temperature is too high
12 Ground
13 Output terminal
red = + black = -
14 power cable with power
plug
15 Switchfor output clamps