User manual

ManualsBrandsSTATRON ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) 0 - 32 V 0 - 3 A

Operating instruction lab

power supply unit

0 ... 32 V / 0 ... 3,0 A

type 2223.2

The intended application of the power supply unit covers:

- link and operation of low-voltage consumers with an operating voltage between 0 and 32 VDC. The power

input of the consumer may not exceed 3,0 A.

Note! Absolutely read!

- Read this guidance exactly. With damage, which is caused by neglect of the guidance, the warranty claim

goes out. For damages we do not take over adhesion.

Table of contents

1 introduction of

2 safety notes (mains connection and protection change) of

3 controls

4 line-up

5 technical data

Summary of content (4 pages)

PAGE 1
Operating instruction lab power supply unit 0 ... 32 V / 0 ... 3,0 A type 2223.2 The intended application of the power supply unit covers: - link and operation of low-voltage consumers with an operating voltage between 0 and 32 VDC. The power input of the consumer may not exceed 3,0 A. Note! Absolutely read! - Read this guidance exactly. With damage, which is caused by neglect of the guidance, the warranty claim goes out. For damages we do not take over adhesion.
PAGE 2
1. introduction this power supply unit is universally applicable with its infinitely variable adjustment possibilities of voltage and current for school, occupation, hobby etc.. An electronic current limiting protects the power supply unit against overloading. Output voltage and - current are electronically stabilized and infinitely variable adjustable. Thus the electronic restraint current can as adjustable Current limiting to be used, in order to protect consumers against a too high power input.
PAGE 3
device or the mains cable visible damages indicates, - the device any longer does not operate, - after longer storage under unfavorable conditions, - after heavy transport stresses. 3. Controls 1. 2. 3. 4. 5. 6. 7. 8. power switches rough and fine automatic controller voltage rough and fine automatic controller current LCD display voltage LCD display current exit hubs DC LED constant voltage LED constant current 4.
PAGE 4
Technical data operating voltage: : 230 VAC +6/-10% frequency: : 50 to 60 Hz power input: : max. 0,6A output voltage: : ca. 0,1 .... 32 V output current: : ca. 0,1 .... 3,0 A voltage stability with +6/ 10% mains : fluctuation: ca.0,05 % load compensating with 100% load change: ca. 0,1% : current stability with +6 / -10 % mains : fluctuation: load compensating with 100% load : change: remaining ripple with nominal load: : ca.