User Manual

Dual-lens Mega-pixel IP Camera

2.2. Quick installation and usage

There are only three things that you need to do to see the video from the IP CAM.

1. Connect the IP CAM to the home/office network.

2. Install the CamView/app software on the notebook/PC/mobiles.

3. Key in the ID/password of the IP CAM(from the ID/Password card) on the

CamView, and then you can see the video.

First, Connect the IP CAM to the home/office network

Please connect the IP CAM accessaries to the IP CAM body correctly, including the

power adapter and Ethernet cable, as shown in Figure 2-3. And connect the other end

of the Ethernet cable to the home network or office network. Usually, this Ethernet

cable is plugged into a home NAT/router device or an Ethernet switch if in the office,

as shown in Figure 2-4. Since the default settings of the IP CAM use DHCP function

and very often there is a DHCP server on most of the Home/office network, the IP

CAM should be connected to the Internet immediately. The Internet status LED is

constant red light to indicate this good connection status. If the LED is blinking, please

refer to section 3.3~3.5 to try other network settings.