User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
gure 29
6 mm hex key
Adjustment screw
Instruction manual
39
Adjust the swivel eort of the monitor arm
• To increase or decrease the swivel eort of the monitor arm, use the 6 mm hex key
to turn the screw in the plate on the back of the column to the right or left.
(gure 29)
Caution! When you loosen the screw, make sure that you don’t remove the screw from
the joint. If you remove the screw, the column will fall o of the monitor arm and could
result in damage to your equipment or injury.