User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
35
Adjust the tilt angle of the monitor
1. If necessary, swivel the monitors so that you can access the two screws in the sides
of each of the VESA monitor mounts.
2. Use the 5 mm hex key to loosen the two screws in the side of the VESA monitor
mount that you want to adjust.
3. Tilt the monitor so that it’s at the angle that you want it at.
4. Use the 5 mm hex key to tighten the two screws in the side of the VESA monitor
mount. (gure 25)
5. If necessary, complete steps 2 to 4 to adjust the tilt angle of the second monitor.
5 mm hex key
gure 25
Adjustment screw