User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
33
Remove monitors from the WALLSTS2
Warning: Stored energy hazard! The column contains a lift mechanism that could
move up quickly when you remove the monitors from the product. Before you remove
the monitors, move the monitors to the highest position. Failure to do so could result
in injury or property damage.
Warning! Removing a monitor is a two-person job. Do not attempt to complete this
task by yourself.
1. Move the monitors to the highest position it can go. (gure 23)
2. Use a Phillips type screwdriver to remove the bottom two M4x10 mm screws from
the back of the VESA monitor mount and monitor.
3. Use a Phillips type screwdriver to loosen the top two M4x10 mm screws from the
back of the VESA monitor mount and monitor.
4. Carefully lift the monitor o of the monitor mount.
5. To remove the second monitor, repeat steps 1 to 4.
gure 23
WALLSTS2 in
upright position
M4x10 mm screw
Screwdriver