User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
32
Route cables
1. Run your cable along the column and through the slot at the bottom of the column.
2. At the top of the cable cover, squeeze the tabs and slide the cable cover up to
unhook the tabs at the bottom of the cable cover from the slots in the monitor arm,
and lift the cable cover o of the monitor arm.
Caution! Be careful not to snap o the tabs from the cable cover when you remove it.
3. Run the cable along the inside of the cable cover. (gure 22)
4. Hook the tabs at the bottom of the cable cover into the slots in the monitor arm,
and push the tabs at the top of the cable cover into the corresponding slots.
gure 22
Column
Cable
Cable cover
Tab
Slot
Slot
Tab