User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
29
2. Carefully hang the M4x10 mm screws onto the keyhole-shaped holes in one of the
VESA monitor mounts attached to one of the crossbars.
3. Insert two of the M4x10 mm screws into the mounting holes in the bottom of the
VESA monitor mount and into the monitor.
4. Use a Phillips type screwdriver to tighten all four of the screws. (gure 19)
5. Repeat steps 1 to 4 to attach the second monitor to the other VESA monitor mount.
gure 19
M4x10 mm screw
Screwdriver