User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
25
Attach the monitors to the crossbars
Warning! Attaching a monitor is a two-person job. Do not attempt to complete this
task by yourself.
WALLSTS2 is a designed to be used with two monitors that weigh the same. If you
attach monitors that are dierent weights to the WALLSTS2, you do so at your own risk.
Use the 100x100 VESA mounting hole pattern to attach the monitors
1. Insert two of the M4x10 mm screws into the mounting holes that are located closest
to the top of one of the monitors. (gure 15)
Note: Do not tighten the M4x10 mm screws, and make sure that you leave between
3 and 4 mm of space between the screws and the monitor.
gure 15
Top of monitor
M4x10 mm screw