User Manual
Table Of Contents
- Warnhinweise
- Product dimensions
- Product diagram
- Technical specifications
- Package contents
- Requirements
- Assembly
- Attach the wall plate to the wall
- Attach the monitor arm to the wall plate
- Attach the column to the keyboard tray
- Attach the column to the monitor arm
- Attach the crossbars to the column
- Attach the VESA monitor mounts to the crossbars
- Attach the monitors to the crossbars
- Attach the adhesive strip
- Route cables
- Remove monitors from the WALLSTS2
- Adjusting the WALLSTS2
- Clean the keyboard tray
- Technical support
- Warranty information
Instruction manual
11
Assembly
Attach the wall plate to the wall
Warning! Wall structures vary, and it is important to make sure that the type of
structure and mounting hardware that you are using will properly support the
mounted equipment. Failure to do so may result in personal injury and/or equipment
damage. The wall should be capable of supporting at least four times the weight of the
mounted equipment.
Warning! The mounting hardware included with this product might not be adequate
for some wall structures. If you lack the necessary expertise to attach this product
to the wall that you are using, contact a construction professional to install the wall
mount or to provide specic mounting instructions for your wall.
1. At the top of the bottom cover, pinch the corners to release the clips and slide the
cover downwards and o of the wall plate.
2. Slide the top cover upwards and o of the wall plate. (gure 1)
Note: Do not throw away the covers, you will need to reattach them later on in the
assembly process.
gure 1
Top cover
Bottom cover
Wall plate
Top of cover