User Manual

If you are unable to display or record video, complete the following in Device Settings:
 Make sure that the input that you are trying to record or display is selected in Video
Source.
 Make sure that the video standard is set correctly for your region (for example, NTSC for
North America, PAL for Europe, and so on).
 If your audio is not working, make sure that you selected the correct audio source
in Audio Source.
If the recorded video is poor quality, navigate to Record Settings and change the following
settings to best suit your setup:
 Record Resolution
o High
o Low
 Record Mode
o VBR (Variable Bit Rate) adjusts the bit rate based on the complexity of the video
and saves space.
o CBR (Constant Bit Rate) maintains the same bit rate regardless of complexity and
offers the best recording quality.
 Record Quality
o The VBR quality level increases from 1 to 10, with 10 being the highest quality
level.
o The CBR quality level goes from 2 Mbps to 16 Mbps, with 16 Mbps being the
highest quality level.
If you are experiencing any issues with streaming, make sure that the following is true:
 The target IP address is correct.
 The correct protocol is selected.
 You tested a low resolution and low bit rate to get the best performance.
Was this information helpful? Yes No
Compliance and Safety
Compliance Letters
 Country of Origin (COO)
o Language: English
 Letter of Conformity (LOC)
o Language: English
 Waste Electrical and Electronic Equipment Directive (WEEE)
o Language: English
Safety Measures