User Guide

Instruction Manual

Beep Codes

Some of the keyboard command sequences you issue to the Remote Unit have

multiple possible settings. The Unit will beep to indicate what setting you have

selected for the command you issued. (A short beep followed by a long beep indicates

an invalid command.)

[Ctrl] - [Ctrl] - [Alt]+[E] (Compatibility Mode)

1 beep: disabled

2 beeps: enabled

[Ctrl] - [Ctrl] - [F11] (Remote Image Quality Adjustment)

1 beep: 0 ~ 130 feet (0 ~ 40 meters) of UTP cable length

2 beeps: 130 ~ 260 feet (40 ~ 80 meters) of UTP cable length

3 beeps: 260 ~ 390 feet (80 ~ 120 meters) of UTP cable length

4 beeps: 390 ~ 500 feet (120 ~ 150 meters) of UTP cable length

[Ctrl] - [Ctrl] - [F4] (Typematic Rate)

1 beep: 6 characters/sec.

2 beeps: 12 characters/sec.

3 beeps: 20 characters/sec.

4 beeps: 30 characters/sec.

Note: Commands described in the [Key] - [Key] format are keys that must be pressed

in order on the keyboard. Commands described in the [Key]+[Key] format must be

pressed simultaneously.

Note: If the NumLock, CapsLock, and ScrollLock lights are ashing in unison on the

keyboard, the other Unit has control of Computer A. You will not be able to use A until

the other Unit releases access to that computer.

Note: If the Extender is operating in Compatability Mode ([Ctrl] - [Ctrl] - [E] hotkey

sequence), you must enter [Ctrl] - [Ctrl] - [E] - [E] to access port E on the attached

KVM switch.