User Guide
Instruction Manual
9
Using the Remote Unit
The Remote Unit allows a user at the Remote Unit to assume control of devices
connected to the Host Unit, if the Host Unit is set to Auto or Remote mode, and it also
permits the user seated at the Remote Unit to use any connected system as though the
KVM Extender was transparent.
You can use either keyboard shortcuts or the mode switch on the top of the Remote Unit
to alternate control between A and B. Unlike the Host Unit, however, the switch on top
of the Remote unit only oers two selectable modes:
LED Indicators
Mode A Indicator B Indicator
Remote Access (Computer A) On (solid) O
Local Access (Computer B) O On (solid)
Standard Command
With Compatibility Mode
Enabled
Description
[Ctrl] - [Ctrl] - [T] [Ctrl] - [Ctrl] - [T]
Toggles console control
between Computer A
and Computer B
[Ctrl] - [Ctrl] - [Esc] [Ctrl] - [Ctrl] - [Esc]
Cancels the hotkey
sequence
[Ctrl] - [Ctrl] - [Alt]+[E] [Ctrl] - [Ctrl] - [Alt]+[E]
Enables (2 beeps)
or disables (1 beep)
Compatibility Mode so
that the KVM extender
will work with a KVM
switch that also uses a
[Ctrl] hotkey sequence
Keyboard Shortcut Command Sequences