User Manual
Instruction manual
10
Automatically ne tune the picture
This option makes the picture sharper and reduces USB trac. The picture will freeze
for about one second while the calibration is performed.
• On the Video menu, click Auto ne-tune picture.
Adjust the position of the image
1. On the Video menu, click Settings.
2. In the Picture Positioning section, do one of the following:
• Click the up, down, left, and right arrow buttons to move the picture. The
directional arrow buttons function similarly to the centering controls found on
video monitors.
• To automatically center the video image within the program window, click
Auto.
• To apply the default settings, click Default.
• To save your changes, click Save.
The adjusted values are automatically applied whenever the same video mode is
displayed again.
Adjust the sharpness of the image
1. On the Video menu, click Settings.
2. In the Sampling phase (Sharpness) section, do one of the following:
• To automatically adjust the image sharpness, click Auto.
• To manually adjust the image sharpness, move the Phase slider.
Adjust the noise lters
The adapter uses the noise lter and the atness lter to reduce USB trac and
improve the picture quality.
The noise lter:
• Helps to remove speckle noise.
• Doesn’t usually display a visual eect, unless you move the mouse to high values
and then some pixels may be left behind.
The atness lter:
• Converts regions that are nearly all of the same color to the same color to aid with
compression.
• At higher values, color banding is much more visible.