User Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation. Changes or modications not expressly approved by StarTech.com could 
void the user’s authority to operate the equipment.
Industry Canada Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two 
conditions: 
(1) This device may not cause interference, and (2) This device must accept any interference, including interference that may 
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation 
est autorisée aux deux conditions suivantes: 
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique 
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only 
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which 
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered 
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the 
property of their respective holders.
Warranty Information
This product is backed by a two-year warranty. 
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents) 
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss of 
business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. 
Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations 
or exclusions contained in this statement may not apply to you.
Safety Measures
•  If product has an exposed circuit board, do not touch the product under power.
Mesures de sécurité
•  Si l’un des circuits imprimés du produit est visible, ne pas touchez le produit lorsqu’il est sous tension. 
安全対策
• 製品に露出した状態の回路基盤が含まれる場合、電源が入っている状態で製品に触らないでください。
Misure di sicurezza
•  Se il prodotto ha un circuito stampato visibile, non toccare il prodotto quando è acceso.
Säkerhetsåtgärder
•  Rör aldrig vid enheter med oskyddade kretskort när strömmen är påslagen.
FR: startech.com/fr
DE: startech.com/de
ES: startech.com/es
NL: startech.com/nl
IT: startech.com/it
JP: startech.com/jp
StarTech.com Ltd.
45 Artisans Cres
London, Ontario 
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Rd, 
Brackmills
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
2500 Creekside 
Parkwy
Lockbourne, Ohio 
43137
U.S.A.
Operation
About the LED Indicators
LED Behavior Signicance
LED is illuminated 
orange
A Computer is selected and a link has been established
LED is ashing orange A Computer is selected but not detected
Hotkey Reference Guide
• Windows® Keyboard: To switch Computers the hotkey combination is Scroll Lock + 
Scroll Lock
• Mac Keyboard (or a Windows Keyboard with no Scroll Lock): Use the Included 
Software to dene the new hotkey sequence.
Note: Each hotkey sequence keystroke should be pressed within two seconds.


