User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
43
Lock the vertical position of the TV
When the TV is at the height that you want it to be at, you should lock the vertical
position of the TV to prevent the TV from moving up or down the column.
Warning! Exercise caution when you pull the pin out of the spool and turn it to the
unlocked position. The weight of the TV may not be counterbalanced and the TV could
free fall down the column or spring upwards, resulting in damage to the TV or personal
injury.
1. Pull the pin out of the spool and turn it to the unlocked position.
2. If necessary, adjust the height of the TV.
3. Pull the pin and turn it to the locked position.
4. To make sure that the pin is properly aligned in one of the holes in the spool, pull
up or push down on the TV. You may hear a clicking sound as the spring-loaded pin
goes into the hole and prevents the spool from rotating.
When the pin is aligned in one of the holes and the TV is locked in a vertical position,
the TV shouldn’t move when you pull up or push down on it.
Caution! If the pin is misaligned and isn’t fully inserted into one of the holes on the
spool, the vertical position isn’t locked and the TV could free fall down the column or
spring upwards, resulting in damage to the TV or personal injury.
5. Close the door on the plastic cover.