User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
39
Adjusting the STNDMTV70
Change the orientation of the TV
You can position the TV in either landscape or portrait orientation on the STNDMTV70.
1. To display the TV in portrait orientation, if present, remove the two M6x8 mm screws
from the back of the support plate.
2. Rotate the TV 90° clockwise.
3. Reinsert the M6x8 mm screws you removed in step 1, and use a Phillips type
screwdriver to tighten them. (gure 30)
gure 30
M6x8 mm
screw
M6x8 mm
screw