User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
29
section.
Counterbalance the weight of the TV
When you add a TV to the STNDMTV70, you need to adjust the lift capacity of the TV
cart to support the weight of the TV. If the lift capacity of the STNDMTV70 isn’t set
correctly, when you let go of the TV, it could free fall down the column or move up the
column unaided, resulting in damage to the TV or personal injury.
Warning! Counterbalancing the weight of the TV requires multiple people. Do not
attempt to complete this task by yourself.
1. At the bottom of the column, pull the pin out of the spool and turn it to the
unlocked position.
2. Move the TV up the column a short distance and loosen your hold on the TV to see if
it remains stationary. Based on what you observe, do one of the following:
• If the TV rises up the column, use the wrench to turn the knob near the
spool clockwise. (gure 19)
• If the TV falls down the column, use the wrench to turn the knob near the
spool counterclockwise. (gure 19)
Warning! If you encounter resistance when you turn the knob, stop turning it. If you
continue to turn the knob, you may damage the TV cart.
gure 19
+
-
Wrench
Knob
Spool