User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
23
Attach the adapter brackets to a recessed mounting surface
To accommodate dierent TV designs, the STNDMTV70 comes with ve sets of screws
of dierent lengths and diameters, TV washers with two hole sizes, and two sizes of
spacers.
Warning! Make sure that the weight of the TV doesn’t exceed the weight capacity of
this product. If you exceed the weight capacity, you might experience personal injury
or damage to the product. This product can support the following weight: 40 kg (88 lb.)
when the lift mechanism is locked or 8 to 25 kg (18 to 55 lb.) when the lift mechanism
is in use.
1. To select the combination of mounting hardware that you need to use to attach the
adapter brackets to the TV, complete the following:
• Determine the depth of the mounting holes on the TV.
• Determine the diameter of the mounting holes on the TV.
2. Consult the images below and on the next page to see the dierent hardware
M6x30 mm screw
M8x30 mm screw
or
or
or
combined with
M8x50 mm hardware combinations are illustrated on the next page
2 small spacers
1 small spacer
1 large spacer
1 large spacer