User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
20
1. To unlock the vertical position of the support plate, at the bottom of the column,
next to the spool, pull the pin out and turn it to the unlocked position. (gure 13)
gure 13
2. Pull the support plate and adapter brackets down until they are at the bottom of the
column.
3. Pull the pin and turn it to the locked position.
4. To make sure that the pin is properly aligned in one of the holes, pull up or push
down on the support plate. You may hear a clicking sound as the spring-loaded pin
goes into the hole and prevents the spool from rotating.
Caution! If the pin is misaligned and isn’t fully inserted into one of the holes on the
spool, the vertical position isn’t locked and the TV could free fall down the column or
spring upwards, resulting in damage to the TV or personal injury.
When the pin is aligned in one of the holes and the support plate is locked in place, it
shouldn’t move if you pull up or push down on it.
Column
Spool
Pin